Check out Symmetric Chess, our featured variant for March, 2024.

Enter Your Reply

The Comment You're Replying To
H. G. Muller wrote on Wed, Mar 6, 2013 07:01 PM UTC:
Unfortunately I never made webpages for this. I did post occasionally results here.

I have now tried to measure a Wazir directly against a Pawn. This was kind of interesting. An obvious way of doing it would be to replace the f- or g-Pawn (the one in front of the Bishop in the shuffled setup) by a Wazir. My Chess intuition immediately revolted against this, however: such a position has none of the characteristics of traditional Pawn odds, which I used to compare other material imbalances against. The Wazir nicely fills the hole that otherwise would be such a liability.

When I was doing Wazirs vs Knight one Wazir was replacing the Q-side Knight, and the other put just in front of it, moving up the b- or c-Pawn one step. To better compare with that, I took a position that did put a Wazir in front of the Q-side Knight, as an extra piece, and deleted the f- or g-Pawn in compensation as Pawn odds.

In fact, the two positions are somewhat reminiscent to comparing the value of an extra Pawn to that of Pawn odds. If I 'replace' the f-Pawn by a Pawn, I of course get an exact wash, as I did not change anything. But if I do it by deleting the f-Pawn, and adding an extra Pawn on c3, I do faithfully create the Pawn-odds motif. Of course any Chess player would know this position is much worse than the usual initial position. Doubled Pawns are worth less than two normal Pawns.

I tried both W vs P positions, and indeed the measurements give significantly different values. A Q-side Wazir and K-side a Pawn hole only show a 50.9% score in favor of the Wazir, hardly significant (1-SD error = 1%), and only 6 cP when taken at face value. But when a K-side Pawn is replaced by a Wazir, the score increases to 55.3% percent in favor of the Wazir (33 cP). That is significantly more (4 SD)! So a Wazir behaves a bit like a Pawn. Put on an open file to replace a Pawn it is worth about 27 cP more than when trapped behind another Pawn. Much like a doubled Pawn. 

Unlike a Pawn a Wazir can move sideways, but it takes so many moves to get from the Q-side to the K-side that this will be too expensive in itself. Unlike with doubled Pawns, there now the situation Wazir behind Pawn or Pawn behind Wazir are no longer equivalent. I expect Wazir in front of Pawns to be better, but did not measure from such positions. This is related to the earlier remark that Rook-like pieces are difficult to develop when they start behind Pawns. Remarkable enough the 27cP difference I measure between open-file Wazir and behind-Pawn-wall Wazir is almost exactly the deficit I usually measure in the Rook value with my method (475cP in stead of 500cP).

Anyway,when I use W = 1.06 x Pawn odds, the 2W vs Knight with Pawn-odds result (40cP in favor of the Knight) would say 3.12 x Pawn odds + 40cP = 325cP (=N), from which follows that Pawn odds = 91cP. So this particular Pawn in the early opening seems worth somewhat less than the abstraction of the 'average Pawn' (which probably corresponds to a well-centered Pawn in the mid-game). That puts the Wazir (behind Pawns) at 1.06 x 91cP = 97cP (where N=325cP). A developed Wazir, (on open file) would be 1.33 x 91cP = 121cP. Compare that to an old result where I played 2 Ferzes against Knight in the same setup (replacing Q-side N by F, and putting the second right in front of it, moving up the Pawn). There the pair proved worth ~300cP, i.e. 150 each average. (Undoubtedly a lone Ferz will be worth slightly less, and the second slightly more, due to its color binding.) Of course the Ferz does not suffer from being behind a Pawn wall; it sneaks out between them.

Edit Form

Comment on the page Buypoint Chess

Quick Markdown Guide

By default, new comments may be entered as Markdown, simple markup syntax designed to be readable and not look like markup. Comments stored as Markdown will be converted to HTML by Parsedown before displaying them. This follows the Github Flavored Markdown Spec with support for Markdown Extra. For a good overview of Markdown in general, check out the Markdown Guide. Here is a quick comparison of some commonly used Markdown with the rendered result:

Top level header: <H1>

Block quote

Second paragraph in block quote

First Paragraph of response. Italics, bold, and bold italics.

Second Paragraph after blank line. Here is some HTML code mixed in with the Markdown, and here is the same <U>HTML code</U> enclosed by backticks.

Secondary Header: <H2>

  • Unordered list item
  • Second unordered list item
  • New unordered list
    • Nested list item

Third Level header <H3>

  1. An ordered list item.
  2. A second ordered list item with the same number.
  3. A third ordered list item.
Here is some preformatted text.
  This line begins with some indentation.
    This begins with even more indentation.
And this line has no indentation.

Alt text for a graphic image

A definition list
A list of terms, each with one or more definitions following it.
An HTML construct using the tags <DL>, <DT> and <DD>.
A term
Its definition after a colon.
A second definition.
A third definition.
Another term following a blank line
The definition of that term.